|
01-29-2020, 11:35 AM
|
#1
|
Senior Member
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 364
|
Changing out TV
Looking to replace our 2011 TV that works just fine with a smart TV. There is very little room to get to the mounting screws that attached it to the powered lift.
Has anyone upgraded their old TV.
Our old one is a Sony Bravia 40"
New 43" will fit just fine. I just can't figure out how to get the old one out.
__________________
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 F-350 CC 6.7 diesel dually, Banks Derringer tuner with super gauge
|
|
|
01-31-2020, 01:12 PM
|
#2
|
Junior Member
Join Date: May 2015
Posts: 4
|
use # 8 Robertson square drive screw driver to remove mounting screws.
__________________
|
|
|
01-31-2020, 06:58 PM
|
#3
|
Senior Member
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 364
|
That doesn't help me figure out how to get to them.bu
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 F-350 CC 6.7 diesel dually, Banks Derringer tuner with super gauge
|
|
|
02-01-2020, 05:12 AM
|
#4
|
Senior Member
Join Date: Oct 2017
Location: Germantown, Tennessee
Posts: 716
|
Mike usually the TV in the main living area is removed by lifting from both ends (usually with a lot of force) and then pulling out again on the bottom and it comes away from the wall.
__________________
Jim and DW 50 years Brenda
2018 40rssa and 2021 Jayco Eagle 40'
2019 F450, ruby red
Harley Road King & sidecar
|
|
|
02-01-2020, 10:06 AM
|
#5
|
Senior Member
Join Date: Feb 2013
Location: on the road
Posts: 1,199
|
OP's TV drops down into the cabinet I believe?
__________________
2015 RAM LongHorn Dually Air ride Aisin 4:10's
2016 MS 39TKSB3 "Highly Elited"
|
|
|
02-01-2020, 10:13 AM
|
#6
|
Senior Member
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 364
|
Yes mine is behind the fireplace on a motorized lift.
It's at the end of the kitchen slide.
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 F-350 CC 6.7 diesel dually, Banks Derringer tuner with super gauge
|
|
|
02-01-2020, 10:42 AM
|
#7
|
Member
Join Date: Jun 2018
Posts: 99
|
This is how my Oct 2015 built RV, TV is mounted. I haven't had my removed on this RV but I would loosen the 2 screws, each side and lift it up and out. Then detach the wiring. Last step remove the mounting frame from the TV.
I had a 2010 Montana that had a lift problem that required the TV removal that was similar to this attachment.
(I love my cell phone camera for working tight spots. Better than a mirror when trying to explain something to your helper. Better than a magnifying glass to see the detail.)
Clay MS 38PS3
|
|
|
02-01-2020, 10:47 AM
|
#8
|
Member
Join Date: Jun 2018
Posts: 99
|
TV mounting bracket (2).jpg
Problem with the previous post loading the picture. It seem I can login, type the message and then it will tell me I'm not logged in. Top right of the page says I'm logged in. Is there time limit?
|
|
|
02-01-2020, 10:54 AM
|
#9
|
Senior Member
Join Date: Dec 2018
Location: Desert Hot Springs Ca.
Posts: 364
|
I didn't think to look at the lift. I was just looking at the TV mount area. I'll take a new look.
__________________
Mike & Trish Romans 10:9
2011 Mobile Suites 36RSSB3 #5556
2017 F-350 CC 6.7 diesel dually, Banks Derringer tuner with super gauge
|
|
|
02-01-2020, 06:55 PM
|
#10
|
Junior Member
Join Date: Jan 2020
Location: Gainesboro, Tn
Posts: 14
|
mine has a different brand of lift but if you look over the tv from the top you can see the bolts that hold the tv mount to the lift pedestal. Remove the tv mount from the lift pedestal then remove the mount from the tv. put the old mount on the new tv then hang the mount back on the lift pedestal.
|
|
|
02-03-2020, 03:38 PM
|
#11
|
Junior Member
Join Date: Sep 2019
Posts: 1
|
TV replacement
Quote:
Originally Posted by MTK46
Looking to replace our 2011 TV that works just fine with a smart TV. There is very little room to get to the mounting screws that attached it to the powered lift.
Has anyone upgraded their old TV.
Our old one is a Sony Bravia 40"
New 43" will fit just fine. I just can't figure out how to get the old one out.
|
I replaced mine in a DRV with the elevator. What I did was I retracted the TV about half way down so I could see behind it from the top. There were 3 screws on top of the mount that I was able to take out and then the TV just picked up off.
|
|
|
02-04-2020, 10:42 AM
|
#12
|
Senior Member
Join Date: Feb 2013
Location: on the road
Posts: 1,199
|
^^^^^ Sounds like a good answer and welcome to the Forum! ^^^^^
__________________
2015 RAM LongHorn Dually Air ride Aisin 4:10's
2016 MS 39TKSB3 "Highly Elited"
|
|
|
06-25-2021, 10:49 AM
|
#13
|
Junior Member
Join Date: Jun 2021
Posts: 26
|
Can you tell me how to replace original Stoney tv in bedroom on 2004 36re and I changed my e-mail I was Mona j and did go out and purchased a 2018 Ram Dually so I should not have a issue pulling over weight thank you for your input at the time
|
|
|
06-25-2021, 05:21 PM
|
#14
|
Senior Member
Join Date: Feb 2013
Location: on the road
Posts: 1,199
|
Quote:
Originally Posted by Bobplouhar0@gmail.com
Can you tell me how to replace original Stoney tv in bedroom on 2004 36re and I changed my e-mail I was Mona j and did go out and purchased a 2018 Ram Dually so I should not have a issue pulling over weight thank you for your input at the time
|
Sorry no help on the TV but congrats on the VERY capable truck!!!
__________________
2015 RAM LongHorn Dually Air ride Aisin 4:10's
2016 MS 39TKSB3 "Highly Elited"
|
|
|
06-25-2021, 08:34 PM
|
#15
|
Junior Member
Join Date: Jun 2021
Posts: 26
|
Quote:
Originally Posted by Cummins12V98
Sorry no help on the TV but congrats on the VERY capable truck!!!
|
Thank you we are newly retired and looking forward to our new travels
__________________
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|