Norcold Fridge 1200 LRIMD control board

[Diesel-Gypsy]

I guess it’s my turn to report a burnt board.
Got the code yesterday morning: No AC
after the usual checks and verifications I pulled the boards cover, and found
a burnt area on the board.
So what is the groups experience with sourcing a replacement board.
I’m a DIY guy, so no need to suggest an RV repair service.
I’m just hoping some of you have done this and where you sourced your board?
My current board is a ;621271001
TIA

[CaptainPalapa]

We replaced our board for our Norcold recently.
https://www.amazon.com/gp/product/B01LXQWVCR/

It was dead simple, took me less than 10 minutes. The fridge is actually colder now! We've been running on just a "1" (vs. up to 9) on the level here in the AZ desert and everything has been nice and cold. (I don't have a thermometer in there, so can't be too specific.)

I replaced the board because we kept getting the LiOP error, and the "magnet trick" no longer worked.

[Diesel-Gypsy]

So this is the start of an update on my Norcold fridge failure.
I’ve ordered a DINOSAUR ELECTRONICS replacement .
Should be here tomorrow, it apparently fits multiple models, so my fingers are crossed it will revive the electric side of the fridge.
I have been running it on LP for the last week, it’s working just fine.

[Diesel-Gypsy]

Alrighty…received and inspected, then read the instructions, and went ahead and installed the replacement Dinosaur Electronics 6212XX control board.
Happy to report the board is working as it should, my Norcold 1200 is now working off AC
Here is what the original board looked like, notice the burnt section.


https://live.staticflickr.com/65535/...f6644c_o_d.jpg